[Qwasmh]

I am working on OKUMA MC-4VAC operating with OSP5020m and i have a problem when transferring G-Code programs to CH0 in machine via RS232C cable.

The problem is character missing in the program with 1000 line or more when revising the machine which sending through CIMCO 6.0 Editor, also when Baud rate of transformation increased missing characters increased.

Communication parameters:
Stop bits: 2.
Baud rate: 600.
Data bits: 7.
Parity: Even.
Flow control/Handshaking: Hardware.
PC O.S: WIN7.
Cable length: 7m.

Thank You,,

[Steamroller123]

I have the same machine and I’m running my baud rate at 9600. It works just fine. I have the proper pin layout for my cable I can give you to compare.??? If you want ?
My problem is after transferring the program into the memory I can’t figure out how to call it over to my buffer so I can run it. ????????????.

I am working on OKUMA MC-4VAC operating with OSP5020m and i have a problem when transferring G-Code programs to CH0 in machine via RS232C cable.

The problem is character missing in the program with 1000 line or more when revising the machine which sending through CIMCO 6.0 Editor, also when Baud rate of transformation increased missing characters increased.

Communication parameters:
Stop bits: 2.
Baud rate: 600.
Data bits: 7.
Parity: Even.
Flow control/Handshaking: Hardware.
PC O.S: WIN7.
Cable length: 7m.

Thank You,,