Re: 1610 CNC Engraver w/Woodpecker 3.2 Controller (Ch340ser driver).
Grbl $I <[VER:1.1 F.20170801:]
[OPT:V,15,128]
OK
Hi,
After powering up controller for the 1st time, the bed does not move away from gantry when clicking the 'UP' arrow Y-axis icon. although a slight click is heard. The stepper motor and wiring do function. My question is, 'Can I troubleshoot the controller board in any way to isolate root cause?' Spindle turns on and all other X, Y and Z axis icons appear to function normally, when clicked.
My last resort is to swap out the controller board, but I don't know where to find a Woodpecker 3.2 replacement. I'm cutting my teeth on CNC engraving and would appreciate any help to resolve problem.
Thanks,
ellie
* 1st post *