Quantity: 2pc
Material: 6061 or 7075 Aluminum (6061 will be cheaper, but if you have surplus 7075 stock, either will work)
Finish: Raw
Tolerances: +/- 0.005"/0.13mm
Edit - I understand the tolerancing might be tight for some aspects of the design. The center bore and the 107.95 Radius that the 12 holes are on, are the two critical dimensions (as well as their concentricity). Otherwise, we can probably be a bit more open.
Message me here, or email me ([email protected]).
Results 1 to 2 of 2
-
10-09-2018, 06:18 PM #1
Neuer Benutzer
- Join Date
- Feb 2013
- Posts
- 5
6061 Aluminum Rotor Hats (Turned, Drilled)
-
10-11-2018, 10:58 PM #2
Registered
- Join Date
- Sep 2009
- Posts
- 135
Re: 6061 Aluminum Rotor Hats (Turned, Drilled)
Quote sent
Sent from my SM-G955U using Tapatalk
Similar Threads
-
7075 bar stock turned and center drilled
By advert in forum RFQ (Request for Quote)Replies: 3Last Post: 11-04-2016, 04:41 AM -
Hex Bar Stock turned and drilled/tapped
By ez3022 in forum Employment OpportunityReplies: 4Last Post: 10-01-2010, 12:04 AM -
RFQ - Turned Steel w/ Drilled & Tapped Set Screws (Cancelled)
By AuroraDrvr in forum Employment OpportunityReplies: 5Last Post: 04-14-2009, 07:12 AM -
RFQ 34 - Small manual job - Offset turned and cross drilled hardened locking pin
By InspirationTool in forum Employment OpportunityReplies: 9Last Post: 09-12-2006, 01:26 PM -
RFQ - small mild steel turned and drilled parts
By mcmmach in forum Employment OpportunityReplies: 8Last Post: 07-29-2005, 03:37 AM
Tags for this Thread
Posting Permissions
