[core units]

Hi,my problem is.Solidcam 2013 can't define coordinate system.
I am trying to test the SolidCAM, so I opened a part file while watching different tutorials on youtube on how to start. I seem to have a problem at the very begging. They are defining the coordinate system in different way which i tried all and it's still not working. First I tried to use a coordinate sys that I created before that. I tried to open just the part file and define a sys by picking up a face center but when I select the face from the graphics area the accept button is not active and no coordinate sys is visualized in the graphics area.Select off rewolution face not work.

[Mikay19]

Hi core units,

I only have 2017 and 2018 on my system. My suggestion is that if you would like to test SolidCAM. Simply call support and they will get you hooked up with a 30 day full posting system so you can really give it a try.

Regards,
Darrin - SolidCAM

[greekart]

Just pick from left side the radio button "origin" and then click where you want to be at your part, it should automate switch to X and to Y picks.