530,122 active members*
3,427 visitors online*
Register for free
Login
IndustryArena Forum > Laser Engraving and Cutting Machines > Laser Control Software > Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
Results 1 to 1 of 1
  1. #1
    Junior Member
    Join Date
    Oct 2018
    Posts
    3

    Red face Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help

    Newbie here trying to find a way to generate reliable G-Code from Fusion 360 to be loaded to my PLanet CNC MK/3/4 controller. I have tried about 15 different Post Processors but either they run into multiple errors are generate G-Code that has a multitude of manual corrections that must be made. Anyone out there have a solution?

  2. #2

    Join Date
    Nov 2018
    Posts
    3

    Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help

    deleted

  3. #3

    Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help

    I am also looking for a post processor for the same setup. Did you find a good one? Please let me know.

  4. #4
    Registered
    Join Date
    Feb 2011
    Posts
    65

    Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help

    I am using EMC2-Lnux pp and works ok until the zero Z axes is on top of the object, now I have modified the PP to stop writing G28&G53 codes. Only attrention is nedded to put the Z axe higher from object.
    Still this is not job done, because I moastly use Z on table (using vaccum table), and need for aditional futures like start vacc, cooling, etc.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •