[noziz]

Dear all,

I have a punch machine with Fanuc 0-P controller.
After replace battery without power on, i have to clear memory to start machine.
But it is strange, i only receive 2 error: 417 and 427 for X,Y digital parameter without error 100: Parameter write enable.
So that, i turned on E-stop(ESP) switch, the screen still show "NOT READY" instead of "EMERGENCY" so i can't input Parameter enable =1 on Setting Handy page.

And its strange, i turn on or turn off E-stop switch, bit 701.5 DGN still =1.
And on the master PCB, SO led red and SI led green light.

Anyone know this problem and can you help me?
Thank for your reading and best regard.

[Robowi]

Murata/Muratec uses switches inside the electrical cabinet to enable parameter setting and other stuff.


Verzonden vanaf mijn iPhone met Tapatalk

[noziz]

Is it your mean?
I turned on this switch.
Today, after replaced 2 socket chip: OE1,OE2; the screen showed alarm "100: parameter enable" and on setting handy page: parameter enable =1.
But i still can't input parameter. So sad.

[Robowi]

Yes, thats the switch I mean. You probably lost all your parameters, so start with inputting the option parameters. They should work.


Verzonden vanaf mijn iPhone met Tapatalk

[noziz]

But i can't input parameter. Eg: in line N000: i type "P 11110101" then press "INPUT" button, but the screen still show "P 11110101" and N000 still 00000000

[mbservice]

But i can't input parameter. Eg: in line N000: i type "P 11110101" then press "INPUT" button, but the screen still show "P 11110101" and N000 still 00000000

Load the option parameters first
Why are you inputting p first
Whereabouts are you ?

[dh08td]

Load the option parameters first
Why are you inputting p first
Whereabouts are you ?

Can you tell me how to input parameter option in c3000 muratec

[Adnan007]

it gives me this error
1019 IN PUNCH CYCLE

[mbservice]

it gives me this error
1019 IN PUNCH CYCLE

Please private message me

[Adnan007]

Please private message me

can you give me your email

or write me privately because I can't write, I don't know why

[mbservice]

[email protected]

[Adnan007]

1037
I/T COUPLING ALARM