hello CNC User, i am trying to setup a new water cooled Spindle and a Vfd.
spec:
2.2k 220v motor, 24k rpm ,400hz , 8.5A
VFD , its a A2--8022 , made by Isaco power control tech. 1 phase in , 3 phase out 220v
Well i test few times what i was think to be the right output but i can't get the voltage to to go up and down on the VSO pin form 0 to 10V+ , i can read 10.56v or 0.4v at pin VSO/Gnd1 , i didn't turn on the VFD while testing the voltage.I don't want to fry the VFd, i want to be sure that i have the right wire connected to the usb control and vfd.
here some screenshot of Mach3 setup and the wire connected to the VFD and controller.
Sorry didn't know how to shrink the images.
https://drive.google.com/file/d/1t4g...ew?usp=sharing
https://drive.google.com/file/d/1YQ9...ew?usp=sharing
https://drive.google.com/file/d/1aLG...ew?usp=sharing
https://drive.google.com/file/d/1PVq...ew?usp=sharing
https://drive.google.com/file/d/1nPA...ew?usp=sharing
https://drive.google.com/file/d/1tGO...ew?usp=sharing
https://drive.google.com/file/d/1xB9...ew?usp=sharing
https://drive.google.com/file/d/1Um-...ew?usp=sharing