Youngquist Brothers inc. is seeking an experienced machinist in Fort Myers, FL.
Experience programming CNC lathes and mills a must.
Experience operating manual lathes, mills, and drill presses also required.
A candidate can expect to work on various short run projects.
No long production runs. Mostly 1 offs or 2-6 units of a part.
Air conditioned shop. Clean work space.
All kinds of projects daily.
One man shop with a helper to assist and clean up.

Our current machine selection consists of:

Okuma Captain L370MW CNC lathe with OSP-P100 control with bar feeder
Okuma LH55-N CNC lathe with OSP-E100L control
Okuma OSP700L CNC lathe
Mazak vertical traveling column mill VTC-20B with Mazatrol M plus control
Kuraki KV-2000 CNC vertical machining center mill with a Fanuc series 16-M controller
Work schedule is Monday-Friday, 7am-4pm with an hour for lunch.

Health, dental, vision, and life insurance is offered after 90 days.

Contact:
Mike Curry
HR Coordinator
Youngquist Brothers Inc.
239-489-4444 x212
• Youngquist Brothers
[email protected]