Hello All,
I know a lot of folks here have used SYNTEC controllers before, I'm having a problem with the following error:
MOT 025 Z Axis Positive Hardware Limit
where I can only rotate the servo one way with the SYNTEC HMI. I've checked the proximity sensor and its registering with the board in the PLC. Also the servo is connected to a DELTA servo driver where I can rotate it CW/CCW no problem. If I remove the connection between the SYNTEC controller an the servo drive before starting up the machine I get the same problem, thus I don't know which signal I'm missing. Thanks in advance for any help/tips!
Regards,
Mol Mott