[nekitamo]

Hi to all...
I have got this JMC servo 180w motor, and find it very good.
I made long one video about this motor


https://www.youtube.com/watch?v=N2bTViQBp10




But just one thing is puzzling if someone can help?
My motor can not go to error when disturb is quick? Only when you overload it gently.
But if you put bigger force you can skip steps easily, like stepper! Is there some settings for that? I cannot find it in Tuning software.
Thanks for listening,
I have video of problem described here: www.youtube.com/watch?v=I6cMBEabw58

[Uguessedit]

Do you have a photo of how you wired it up? It’s hard to tell by video with the camera moving. I have 3 of those motors and for some reason none of them will move. When I went to download the debugging software from Jax the download is incorrect so I can’t check internal settings to see if there is a compatibility issue.

Hi to all...
I have got this JMC servo 180w motor, and find it very good.
I made long one video about this motor


https://www.youtube.com/watch?v=N2bTViQBp10




But just one thing is puzzling if someone can help?
My motor can not go to error when disturb is quick? Only when you overload it gently.
But if you put bigger force you can skip steps easily, like stepper! Is there some settings for that? I cannot find it in Tuning software.
Thanks for listening,
I have video of problem described here: www.youtube.com/watch?v=I6cMBEabw58