Several years ago I started to build a CNC router, but life got in the way. It is time finally for me to carry through. I purchased 4 stepper motors model 34HS9801 from MotionKing. What I didn't realize at the time was that these are 65V motors, rather than 48V.
It would be more economical for me to find a power supply that buy 4 new steppers. Granted, 65V supplies are difficult to track down. I did find this one, and was wondering if it would carry the load for 4 steppers, 2 on the Y, the X, and Z
(PSVHP-65-1200) 65V 18A High Efficiency Desktop Power Supply
It says it is 65V 18A. It costs about $220, but again that is cheaper than laying out over $400 for new steppers.
Any help or advise would be appreciated.
Thanks