584,860 active members*
5,163 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1

    MK3/4 Axis Speed Issue

    I am rebuilding my CNC router controls with a MK3/4 and DQ542MA drivers. I have 2 ball screws on my main axis connected to axis 2 with 4 slaved. When I tested this setup, everything works fine.

    The X axis is connected to Axis 1 with the same settings. When I run it, the DRO looks correct but the movement is only a very small fraction of what it should be.

    The settings on all 3 drivers are the same, they are wired the same, and the axis steps/rev are the same.

    Can anyone point me in the right direction to troubleshoot this issue? Thanks!

  2. #2
    Join Date
    Mar 2017
    Posts
    1295

    Re: MK3/4 Axis Speed Issue


Similar Threads

  1. Replies: 3
    Last Post: 04-20-2019, 11:24 PM
  2. Replies: 2
    Last Post: 08-25-2017, 07:55 PM
  3. Seems Z and A axis are not running...Motor issue or Step/Dir issue?
    By Cattle in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 04-12-2016, 08:51 PM
  4. Issue with Mach 3 Speed when running 4 Axis
    By redneck_cues in forum Mach Mill
    Replies: 3
    Last Post: 11-30-2014, 02:11 AM
  5. Mach 3 Speed Issue on four axis foam cutting setup!!
    By Domdonder in forum CNC Wire Foam Cutter Machines
    Replies: 3
    Last Post: 04-01-2014, 02:02 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •