[amitkumar171]

Dear all

I am using kflop motion board and KMotionCNC.

In that software as i have seen that in fixture offset table X,Y,Z,A,B,C only these axes available but i want to offset U and V axes as well.

I tried using G92 Uxxx. But this is not working.

Please help me out with this problem.

[TomKerekes]

Hi Amit,

It seems to work for me.

I tested with U axis resolution 100 counts per inch and U axis = KFLOP axis #6

Executing this GCode:

G20 (inch mode)
G92.1 (Clear G92 offsets)
G0U2 (Move to machine 2 inch)
G92U0 (Set G92 offset to make this the origin)
G0U1 (Move to 1 inch using this origin - actual machine position is 3 inches)
M30

Then KFLOP shows this (#6 Destination = 300 = machine position 3 inches)

Attachment 406034