[khadgar]

Hi there. I installed Grblgru. I have connected arduino mega with ramps and i get to following error. I didn't edit in any way the config file by the way.

Please help.

[GrblGru]

Can you please give us more details about the error.
What error message is displayed ?
Which Mega-5X version and which GrblGru version are you using ?
When exactly does the error occur ?

[khadgar]

First it gives me a pop up window error message that says:

>G10 L20 p1 x0 y0 z0 a0 b0<
Grbl error:9

G-code lockedd out during alarm or job state.
See controller windows for details

GCode transmition is aborted

And then in the controller window below it shows the following


grbl 1.2h ['$' f
ok
ok

[MSG:Caution: Unlocked]
ok

Grbl 1.2h ['$' for help]
[MSG:Check Limits]
[MSG:'$H'|'$X' to unlock]


I am using this Mega-5x version
https://github.com/fra589/grbl-Mega-5X

The GrblBru V5.0.10

Nothing occurs

Thank you for your reply

[GrblGru]

It looks like you are using a Mega-5X version that does not support all of your axes.
When installing GrblGru, in the directory Program(x86)\toe\GrblGru xxx
the file 'grbl-Mega-5X-v1.2d_XYZAB_SPINDLE_PWM_ON_D6.hex' is
stored.
Use the program 'XLoader' to flash your Mega-5X controller with this file.
This provides the axes X, Y, Z, A and B.