585,705 active members*
3,835 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Haas Machines > Haas Mills > General quesion on Haas VMCs

Thread: General quesion on Haas VMCs

Results 1 to 3 of 3
  1. 11-13-2019, 09:56 PM #1
    Bill_B
    Bill_B is offline
    Join Date
    Jun 2019
    Posts
    9

    General quesion on Haas VMCs

    Have a general question about how the models of Haas mills are structured. I've been looking at older VF0 VF1 and VF2 VMC mills from the late 90s early 80s as this is around where my budget is. 15K and under. My question is does the model dictate the table size?
    Reply With Quote Reply With Quote
  2. 11-14-2019, 05:49 PM #2
    djr76
    djr76 is offline Registered
    Send a message via MSN to djr76
    Join Date
    Nov 2007
    Posts
    479

    Re: General quesion on Haas VMCs

    Quote Originally Posted by Bill_B View Post
    Have a general question about how the models of Haas mills are structured. I've been looking at older VF0 VF1 and VF2 VMC mills from the late 90s early 80s as this is around where my budget is. 15K and under. My question is does the model dictate the table size?
    VF0 26X14
    VF1 26X14
    VF2 36X14

    You can find all the specs at haascnc
    Reply With Quote Reply With Quote
  3. 11-14-2019, 08:37 PM #3
    Bill_B
    Bill_B is offline
    Join Date
    Jun 2019
    Posts
    9

    Re: General quesion on Haas VMCs

    Thanks
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Are Haas VMCs Too Proprietary to Wire in a non-Haas 4th/5th Axis?
    By torinwalker in forum Haas Mills
    Replies: 4
    Last Post: 06-28-2013, 02:00 PM
  2. Carousel Disk for Haas VMCs
    By C.M.I. in forum News Announcements
    Replies: 1
    Last Post: 11-20-2009, 09:16 PM
  3. General Haas VF Question
    By coloradoskibum in forum Haas Mills
    Replies: 5
    Last Post: 10-31-2009, 02:43 PM
  4. haas - general opinion
    By emceul in forum Haas Mills
    Replies: 20
    Last Post: 10-18-2006, 05:22 AM
  5. Quesion regarding inhibit jumper settings for Fanuc drive
    By cncboy in forum CamSoft Products
    Replies: 1
    Last Post: 03-08-2005, 12:43 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules