585,753 active members*
4,432 visitors online*
Register for free
Login
IndustryArena Forum > WoodWorking Machines > DIY CNC Router Table Machines > CNC Wood Router Project Log > can i fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 )?

Thread: can i fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 )?

Results 1 to 2 of 2
  1. 11-26-2018, 01:42 PM #1
    abdelkrim30
    abdelkrim30 is offline
    Join Date
    Nov 2018
    Posts
    2

    Exclamation can i fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 )?

    Hello, friends, I have some questions. I hope you will help me in answering them.
    Yesterday I finished making my CNC machine table but there are some mistakes in the measurements because the iron bar I used was not 100% straight.
    This simple diagram shows the place of simple curvature in iron bar.
    https://files.fm/u/knuw8wwx#/view/cnc.jpg

    My question is whether i can fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 ) or i should make a new table . and thank you for help
    Reply With Quote Reply With Quote
  2. 11-26-2018, 08:45 PM #2
    warrenb
    warrenb is offline Registered
    Join Date
    Mar 2008
    Posts
    683

    Re: can i fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 )?

    1cm seems like a lot. Cut the bar and re weld it to a closer tolerance. Then use a spoil board that you can machine flat. That's about how every CNC is made.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. can i fix this directly from the cnc softwars (GRBL / LINUXCNC / MACH3 ) ?
    By abdelkrim30 in forum Open Source CNC Machine Designs
    Replies: 0
    Last Post: 11-26-2018, 01:38 PM
  2. Arduino GRBL VS LinuxCNC
    By valmar in forum DIY CNC Router Table Machines
    Replies: 57
    Last Post: 01-15-2018, 05:50 PM
  3. GRBL logging with linuxcnc.
    By samco in forum OpenSource Software
    Replies: 2
    Last Post: 06-04-2015, 02:21 PM
  4. grbl vs mach3 vs linuxCNC
    By speed_racer in forum Benchtop Machines
    Replies: 0
    Last Post: 05-08-2015, 02:37 AM
  5. Should I use LinuxCNC or grbl/arduino?
    By CptanPanic in forum LinuxCNC (formerly EMC2)
    Replies: 3
    Last Post: 04-23-2012, 07:06 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules