[the66mustang]

Hello,

Your request to join the HobbyCNC group was not approved.
The moderator of each Yahoo! group chooses whether to restrict
membership in the group. Moderators who choose to restrict
membership also choose whom to admit.

Please note that this decision is final and that Yahoo! Groups
does not control group membership.


verry nice , seems to be i must hangin here for to getting some info?

[bohelle]

You must buy something from Dave at Hobby CNC to get in.

[setcode]

Same here:stickpoke

[toneV8]

You need to buy something from hobbycnc. to join HobbyCNC group.

[the66mustang]

i already did , and already the next order is also comming from dave, so that would not be the problem ? i did buy from hobbycnc ?

[setcode]

Dave wrote:
Be sure to enter your name and what
you purchased in the comments field.
Still awaiting approval

[wwalderbac]

I am sorry for not adding more information. My name is William Walderbach and like I said I am new to this and hopefully be a novice very fast. I have bought the HobbyCNC EZ Board as a kit with three step motors. All I am is looking for a full size layout for the Patec D-4 plastic box. I got a reduced size one from Dave, but I would like a full size one.What happened I moved and misplaced the original layout.
On a side note I have the time now to finish soldering the board together and hope to have everything up and running within a month or two. I would be greatly appreciated.

thanks

[amjones51]

I purchased this kit a while back, and have just now got it hooked up to the steppers. All the voltages checked out according to the directions, so I powered the system up. I went thru the setup with Mach3, but have not been able to get the steppers to turn.
Is there a procedure that I can follow to ensure that everything is set correctly.
I am rather in-experienced with steppers.