Any one have a suggestion for an inexpensive power supply.
I would like a 48 volt through 60 volt 30 amp or so.
Thanks
Any one have a suggestion for an inexpensive power supply.
I would like a 48 volt through 60 volt 30 amp or so.
Thanks
Something that big won't be cheap.
PS-15N56 - 1500W 56V Power Supply - AnTek Products Corp
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for the tip,
As you well know, Unregulated Power Supplies can momentarily go beyond their rated output. These claim 200% for a few minutes. This will allow for a smaller one to be used. These Tecnik Servos can peak at 12.5 amps each.
This one will work in those conditions.
PS-10N56 - 1000W 56V Power Supply - AnTek Products Corp
Plus, what are the odds that all three motors will go into overload at the same time?