We have recently bought Utas ( Osai A-B 8600 Control )cnc Milling Machine with an OSAI – Allen Bradley 8600 control system. This unit when purchased by us was not working
We are kindly request help in guiding us to sort out the below mentioned problem.( We change the battery cause the one we get it in the control was totaly Empty)
When the machine is powered on the following messages are shown on the screen:
SERIES 8600 ver 3.0
DISC????
BUBBLE????
CMOS????
EPROM????
***INIT ABORTED***
I think we have to enter the Machine Parameters?
As we don’t have the maintenance manual for this Mc – could you kindly assist us as to what “inputs” have to be entered for the details mentioned above? Where in your view might the problem be ?
Are there any 8600 manuals ( service – troubleshooting – maintenance – programming ) - available –
Any guidance would be greatly appreciated & helpful.
Many Thanks in advance,
Regards
Eng. Yehia Abdou