[BillWood]

Hello,

What is the transverse hole underneath the spindle for in the sherline mini lathe please ?

See attached picture. Underneath the headstock locking screw.

Usually in photos it has a silver cap or a black cap plugging the hole.

Bill

[ripperj]

I have not had my Sherline in years, but I think it’s for a lever that ties the lead screw to the threading gears, comes with the threading kit, which at first glance seem cheesy, but works really well


Sent from my iPhone using Tapatalk Pro

[Superman]

Is it a through cast hole ?
.... many machines have such holes for slinging so that people don't try to lift the "heavy" end by tying a rope aronnd the headstock.
.... putting a round bar through, a sling on each side plus a sling to the tailstock end gives you a stable 3 point lift.

[ripperj]

Is it a through cast hole ?
.... many machines have such holes for slinging so that people don't try to lift the "heavy" end by tying a rope aronnd the headstock.
.... putting a round bar through, a sling on each side plus a sling to the tailstock end gives you a stable 3 point lift.

It’s a Sherline, weighs a few pounds


Sent from my iPhone using Tapatalk Pro

[Superman]

It’s a Sherline, weighs a few pounds

ahh .... that's why I asked if it was cast...
.. if it is, then, there is no other functional use, other than for manual handling, like threading a rope thru.

[ripperj]

As I mentioned:
https://www.sherline.com/product/310...ng-attachment/


Sent from my iPhone using Tapatalk Pro

[BillWood]

As I mentioned:
https://www.sherline.com/product/310...ng-attachment/


Sent from my iPhone using Tapatalk Pro

Thankyou.

Bill

[CNC-Joe]

It is definitely for the threading attachment. I'm not sure of anything else it is used for