CNC USB MACH3 100Khz Breakout Board problem with auto tool probe .not work with the plugin( RnR MOTION plugin).I would ask for instructions on this board??thanks
CNC USB MACH3 100Khz Breakout Board problem with auto tool probe .not work with the plugin( RnR MOTION plugin).I would ask for instructions on this board??thanks
Probing does not work properly with most of the chinese Mach3 controller boards.
Make sure the probing macro you are using does not use the GetVAR() command, as that's often where they fail.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
in the Diagnostic window in mach 3 digitize bright continuously picture scheme of connection...
Try to invert active state of probe signal in settings.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
What Jerry wrote.
Cheers
Roger