[batadjero]

CNC USB MACH3 100Khz Breakout Board problem with auto tool probe .not work with the plugin( RnR MOTION plugin).I would ask for instructions on this board??thanks

[ger21]

Probing does not work properly with most of the chinese Mach3 controller boards.

Make sure the probing macro you are using does not use the GetVAR() command, as that's often where they fail.

[batadjero]

in the Diagnostic window in mach 3 digitize bright continuously picture scheme of connection...

[ZASto]

Try to invert active state of probe signal in settings.

[batadjero]

Try to invert active state of probe signal in settings.

this board definitely has a problem

[RCaffin]

What Jerry wrote.

Cheers
Roger