[NITROCHUCK]

I'm having trouble running code with my Delta 20...
It loads no problem...code is generated by CamBam and it "looks" Dynapath compliant to me...
No spaces...
1 G command per line...
First line N10....
CR LF end of block commands....
Numbered lines....
END at end...
Looks fine and loads fine then error message at line 10....
130 improper character....
The display version on the control has a bunch of spaces added in that aren't in the raw code.... I'm assuming that's the issue...
I can write a quick test program on the control and it will run great....
If I load that same code from my laptop it adds spaces and gives an error message....

[gwiz]

Just a simple note the the CR is carriage return and LF is line feed. These should not be characters that show on the screen but general formating. I think that is your problem. Not familiar with your CAM but in the setup it may ask if you want a CR or LF at the end of every line. Good Luck