Left the machine not estopped overnight, not my normal practice. But I warmed it up in the morning and everythings been going well.
Experimented with G88 and the machine hung above the part cycling but nothing going on besides that. Halting the program and restarting, trying to run a different one, etc. Nothing worked. The tool changer wouldn't sync up so I couldn't change tools verify tools etc.
Hit estop to shut down and the entire machine went dark. Giving it a few minutes it booted back up but when I homed it started going in the wrong direction on X. Aborted that, its now powered down. Giving it a breather now while I post this. Opened the back door in case it was a heat issue but I don't feel anything abnormally hot.