Hello Folks, Just after Christmas, I had to get some parts machined. As luck would have it, my AMC spindle drive went south on me. Fortunately, I still have my small mill to get the needed parts done. Glad I didn't sell it
My Fadal is a 3016L and my question is, can a generic, non-Fadal VFD be used on these Fadal's. I see 20hp VFD's on eBay go for a lot less than a new or repaired one from one of the Fadal parts suppliers. The reason I ask is that on another forum, someone mentioned that Fadal has the manufactures install special eproms in thier VFD's.
If I go the new inverter route, is one better than the other???? The suppliers have Baldor, Glentek, Yaskawa, and AMC. Any opinions on these drives ????
Thanks!!!!