I just picked up a Tree 325 and all indications are pointing to a dead controller but I'm still unsure.
When I first got it wired up, everything powered up; but the monitor was dead.
I was 100% under the impression that it was a Delta 10 controller until I opened the computer up..
The CPU chassis is a Delta-10 Chassis
Delta 10 Processor board
S10 CMOS RAM board
S20 Peripheral Control board
S20 Graphics Controller board
S10 Panel/PIC interface
S10 Transducer
S10 Servo output
and a System 10 control board
After a few thousand power cycles now the monitor powers up but it is pretty screwy.
I've been trying to at least get the servo drives powered up to verify the controller actually works but I haven't had any luck at doing anything.
Release E-Stop, hit Reset 5000x Still nothing..
Pressing keyboard buttons, panel buttons; I am not getting any other response out of the screen. I've tried adjusting every knob in the back but still nothing.
I really have no idea what to look at now :tired: