584,849 active members*
4,105 visitors online*
Register for free
Login
Results 1 to 3 of 3
  1. #1
    Join Date
    Oct 2017
    Posts
    4

    macv-3 atc10-e tool change

    takisawa mac v-3 atc tool changer problem


    hey there i have a takisawa mac v-3 mill.fanuc o-m control and an atc 10-e tool changer on a 24 tool magazine that comes out through the back of the machine.
    all parameters where lost and i believe that i have replaced all of them including the 9001 macro..
    here's my issue....
    running the tool change program to load tools,the machine stops completely when m80 comes up...and it will just sit there forever.it will not time out or go into alarm..the door opens but the tool magazine will not wont come out.
    same thing in handle..i can press the solenoid for it to come out and it does. it will rotate and do what it should.and then reverse back in and close the door.
    it gets signal to reverse the mag but does not get signal to the solenoid to go forward..
    relays are good and solenoid is also good.
    z zero and z secondary are also good.
    diagnostic shows everything is satisfied for the magazine to come forward.
    i'm stumped and have had two companies out here checking it out to no avail.
    maybe missing a specific parameter?
    I WOULD REALLY APPRECIATE SOME HELP:idea:
    THANKS

  2. #2
    Join Date
    Dec 2009
    Posts
    947

    Re: macv-3 atc10-e tool change

    i assume that the M80 must push the magazine foward.
    this command must ahev a related output like YXX.X and if you do not see the ladder,becasue is 0M-A or B ,you can check that output in diagnose
    So check in your electrical diagram for the magazine foward output adress and see in diagnose if it getting 1 on M80 command.
    if is not getting 1 it means that you stiil need a condition,if it is getting 1 and the realy is not on ,that means a bad cable from I/O board to the relay board.
    You did not say if the spindle is orientated or not and confirmed.
    Good luck

  3. #3
    Join Date
    Oct 2017
    Posts
    4

    Re: macv-3 atc10-e tool change

    hey zavateandu, yes m80 is mag forward.the spindle does orientate and confirm.i will check the cable from the i/o board.
    thanks i appreciate your help.i'll get back with you later on.

Similar Threads

  1. Change time delay in tool change program
    By bspear in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 08-30-2018, 04:01 PM
  2. Bridgeport boss 6 quick change tool holder not holding tool properly.
    By TBCind in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 04-04-2017, 06:56 PM
  3. Replies: 6
    Last Post: 05-10-2016, 12:30 AM
  4. How to change Tool change position(About MAZATROL T1 control)
    By liushuixingyun in forum Mazak, Mitsubishi, Mazatrol
    Replies: 6
    Last Post: 01-07-2014, 01:33 AM
  5. How do I change the Tool Change Position?
    By RussMachine in forum Tormach Personal CNC Mill
    Replies: 4
    Last Post: 01-04-2014, 08:08 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •