Hi,
Wondering if anyone has experienced the noise I have with my HSD 929 spindle. I have just replaced it with a new shaft kit so the bearings should be fine. I did notice that with the old shaft that there was a similar sound at start up/warm up but then it would disappear. This leads me to think that there is an issue with the housing unit. The sound is quite tinny and sounds as if something is loose (at the 30 second mark of the video it seems to correct itself slightly) but I've refitted to make sure that all bolts are secure so there shouldn't be a problem there.
Any advice would be greatly appreciated.
Cheers
IMG 1698 - YouTube