[snbinc]

Hello,

I would like to first off thank everyone for providing help with the problem I face.

A few months ago I purchased a package (VFD and Spindle) as follows:

Dirise ES100 VFD
Manual: http://www.dirise.cn/forum/filesyste...xA0NbrCFj67qGw
Model: DRS ES100-2S-1R5
220V
Single Phase
10A

Spindle:
1.5KW Water-cooled
220V
400Hz
5A

I never received any parameter setup information and am afraid to just guess as I am told to make sure the setup is absolutely correct else I can damage the inverter/spindle.

If anyone has a similar setup or can please provide some assistance.

Thanks,
SNB.

[mactec54]

Hello,

I would like to first off thank everyone for providing help with the problem I face.

A few months ago I purchased a package (VFD and Spindle) as follows:

Dirise ES100 VFD
Manual: http://www.dirise.cn/forum/filesyste...xA0NbrCFj67qGw
Model: DRS ES100-2S-1R5
220V
Single Phase
10A

Spindle:
1.5KW Water-cooled
220V
400Hz
5A

I never received any parameter setup information and am afraid to just guess as I am told to make sure the setup is absolutely correct else I can damage the inverter/spindle.

If anyone has a similar setup or can please provide some assistance.

Thanks,
SNB.

Do or can you get a English VFD Manual, no problem once I have that to give you a Parameter list, I will try and find one

[snbinc]

Do or can you get a English VFD Manual, no problem once I have that to give you a Parameter list, I will try and find one

Sorry didnt realize it was a Chinese manual!

Here is the english manual: http://www.dirise.cn/forum/filesyste...hyLG4gNmOGK4JM

[snbinc]

I also noticed that the VFD is rated for 300Hz while my motor is 400Hz, could this potentially limit the full power of my motor?

[mactec54]

I also noticed that the VFD is rated for 300Hz while my motor is 400Hz, could this potentially limit the full power of my motor?

Then this VFD is not suitable for your spindle it has to match the spindle Hz, see if the seller will change it for you

[snbinc]

Then this VFD is not suitable for your spindle it has to match the spindle Hz, see if the seller will change it for you

Understood, have a bigger problem then :-)

Thank you for all your help!

[mactec54]

Understood, have a bigger problem then :-)

Thank you for all your help!

When you get it sorted I'm here to help you set it up even if it is a different VFD Drive manufacture