501,886 active members
7,747 visitors online
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Registered
    Join Date
    Dec 2011
    Posts
    18

    Question Acoustic isolation of dust collector

    I'm not sure if this is the right section (there are so many!) and before post I did a search, but perhaps I didn't use the right words.

    In a few days I will receive my new machine and I'm equipping my lab with the mandatory accessories. I bought a dust collector (Holzmann Absaugung ABS 850) but for a mistake (my fault) the noise level is louder than expected. It's hard to find anything below 70 dB, so I'm going to keep it and try to reduce its noise. I live in a flat and I cannot use it as is.

    I wonder if a DIY cabin closed on each side with sound proof panels of 50 mm polyurethane would be enough to cut the noise of 10-12 dB.
    I found a lot of such a panels but they say are for musical studios and their primary application is to "clean" the sound. I'm not sure what type of panels I should buy to maximize the acoustic isolation though the cabin.

  2. #2
    Registered
    Join Date
    Mar 2018
    Posts
    35

    Re: Acoustic isolation of dust collector

    There are many videos and infos available if you search for "sound proof cnc (or vac/compressor) enclosure".

    https://www.youtube.com/results?sear...+vac+enclosure

    http://<a href="https://www.youtube....d2nhNf9Tp8</a>


Similar Threads

  1. Dust collector setup,dust hood setup,power connecting
    By allencncrouter in forum Videos
    Replies: 0
    Last Post: 12-17-2018, 02:47 AM
  2. Dust collector
    By popspipes in forum Tormach Personal CNC Mill
    Replies: 30
    Last Post: 07-02-2016, 01:43 AM
  3. Router / Dust shoe without vacuum or dust collector / Wind Deflector
    By ajean in forum DIY CNC Router Table Machines
    Replies: 6
    Last Post: 12-12-2015, 07:42 AM
  4. Dust collector
    By SPEEDRE in forum DIY CNC Router Table Machines
    Replies: 4
    Last Post: 06-30-2007, 02:45 PM
  5. Let’s see that’s dust collector
    By automizer in forum DIY CNC Router Table Machines
    Replies: 5
    Last Post: 03-15-2006, 01:41 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •