[nateman_doo]

Lathe power up. Its a Grizzly G0750g 12x36 gunsmithing lathe. https://cdn0.grizzly.com/manuals/g0750g_m.pdf




I just figured out how to push that blue dial on the right in, give it a quarter turn and it locks in, but that red button wont stay in. No idea what to do.

[nateman_doo]

I should mention that the lathe does power on... but the power feed button doesnt.

[Jim Dawson]

Did you check the fuses?

[nateman_doo]

the fuses were fine. they would have lit up if they were bad.

figured out the problem. KA0 needed to be reset. I didnt even know you could do anything with these things. Called tech support and they talked me through the problems. The cover comes off, and I touched it slightly and it fell back into place like a GFI contact and it fired back up. I knew it was something simple. Hopefully if someone else has this problem after a crash, they find this thread.