I would like advice on connecting a G540 to a speed controller for a brushed 110 VDC motor ( stock motor on a Sieg X2 mill)
I will use mach 4 and have a UC100 to connect to the G540.
My main concern is connecting the Gecko G540 pins: VFD GND(pin7), VFD OUTPUT(Pin8), VFD +10VDC( Pin 9).
Attached is the picture from the Controller "instructions" and a link to the controller sales website.
(https://www.aliexpress.com/item/HX-P...65962e0eNK8xFg)
Could someone confirm that :
Gecko Pin 7 connects to controller pin marked GND
Gecko Pin 8 connects to controller pin marked PWM
Gecko Pin 9 connects to controller pin marked 0-10V
Attachment 412296