It has worked until today when I coupled a rotary drive stepper to it. I have tried to remove the A-axis wire from the drive, but it´s still the same. I can reset Mach3, but when I push the buttons, only the numbers on the screen are running but not the steppers.
What may be wrong?
Results 1 to 20 of 26
Threaded View
-
02-09-2019, 11:10 PM #1
Registered
- Join Date
- May 2006
- Posts
- 309
Red "fault" light is lighting on my G540.
Reply With QuoteSimilar Threads
-
How can do ""manual stepper motor sizing for "rack and pinion"calculation""???
By Medhat93 in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 03-03-2018, 01:50 AM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
G540 fault light...what does that mean?
By HereinCS in forum DIY CNC Router Table MachinesReplies: 3Last Post: 03-07-2011, 02:37 AM -
GECKO G540 - Stuck in "FAULT" mode.. HELP!?!
By CNC74 in forum Benchtop MachinesReplies: 5Last Post: 02-06-2010, 09:37 AM -
New member with a "Fault Light" question.
By kweitz in forum Community Club HouseReplies: 1Last Post: 09-05-2009, 04:32 PM
Tags for this Thread
Posting Permissions
