Hello,
I have been running a Tormach PCNC 1100 for about 7 month. Most of the time I cut plastics, Aluminum, Delrin, etc. But they need to rough some part out of SS316. There are a lot of ideas about feeds and speed for that kind of material. I got some 1/4 endmill 4 flutes special for that material, and the feeds and speeds that they recommend me are:
IPT = 0.0015
SFM = 265
In my opinion that looks a little fast but I do not know what you guys recommend me
I am not a native english speaker so sorry for my gramatical mistakes