I have a Taiwan Takisawa EX108 Lathe that I am getting an Alarm 11 on the spindled amplifier. I sent the Power Supply and Spindle Amplifier to be tested and they tested fine. I just put in a new magnetic connector to take care of one of the problems. I was hoping that would solve the problem, but I am still getting the error.
I can give more particulars leading up to this problem if that will help anyone.
Right now I am at my wit's end trying to get this thing back in production.
If anyone has any ideas, I would greatly appreciate your input.
Thank you,
Ardis
Thread: Fanuc spindle amplifier alarm 11
Results 1 to 2 of 2
-
05-15-2007, 03:00 AM #1
Registered
- Join Date
- May 2007
- Posts
- 29
Fanuc spindle amplifier alarm 11
-
05-15-2007, 11:10 AM #2
Registered
- Join Date
- Aug 2006
- Posts
- 98
Ardis,
This Alarm, i think that you has in spindle amplifier alarm 11 and in power suplly alarm 7, means DC linker overvoltage. Probably, your power suplly to comes in the machine is too high !!! How much is these power suplly ??? Check this information !!!
Daniel
Reply With QuoteSimilar Threads
-
FANUC 11M Amplifier bad, need help!
By posedi in forum FanucReplies: 3Last Post: 11-11-2009, 04:50 AM -
Spindle drive alarm in fanuc 16 ta
By miguisu in forum FanucReplies: 3Last Post: 02-20-2007, 05:12 PM -
Spindle enable alarm Fanuc OTB
By hien100881 in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 01-21-2007, 08:29 AM -
Spindle Servo Alarm, Fanuc 3m, Help!
By MITYDR in forum FanucReplies: 1Last Post: 07-03-2006, 03:31 PM -
FANUC 11M Amplifier bad, need help!
By posedi in forum DNC Problems and SolutionsReplies: 2Last Post: 04-19-2006, 04:10 PM
Posting Permissions
