Re: Will LinuxCNC allow this type of commands
This is basically a drag knife (however uses a round blade). If you go to either carlsondesign.com or autometrix.com you will see these machines.
The 28mm razor blade just rolls along (sort of like a pizza cutter does). The Z axis steers the blade in the direction of the XY motion. On the Autometrix machine the blade holder is fixed and not allowed to swivel which is better than the carlson system that allows it to swivel. We've bad both machines. I kept the old carlson machine and am just trying to upgrade it.
I posted over in the LinuxCNC forum but got no response....
The Body Armor Dude - Andrew