I have recently purchased a turret for my Prolight 3000 lathe. It didn't originally come with one, so I don't have the cable to connect it to the control box. The turret is from a parted-out Prolight, so I do know it's the right one for the machine. The rest of the lathe is working fine on the original control and software, I just need the cable. I contacted Intelitek, but got no response, so I'm hoping someone here can help me.

I figure I can make my own cable but I need to know the pinout. If you have a late 90's Prolight 3000 with the factory turret, can you please check the cable and post the pinout? The cable I am looking for has a round 8-pin connector on the one end, and a D9 connector on the other end. I need to know which pin on one end goes to which pin on the other end. I can source the connectors and make the cable, unless someone has an old one lying around they don't need any more... I'd rather buy it than make it, but I can make it if necessary.

Thanks in advance for any help you can provide.