584,846 active members*
4,202 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > How to bypass Linear scale in Fanuc Oi-MF controller
Results 1 to 8 of 8
  1. #1
    Join Date
    Feb 2019
    Posts
    2

    How to bypass Linear scale in Fanuc Oi-MF controller

    Hi! All,
    I have one drill tap center with Fanuc Oi-MF. All three axis have linear scale and one failed in Y axis.

    I tried to bypass it through 1815#opt but got alarm of SV411 which I avoid by adjust the 1829 parameter.

    Now repeatability is effecting by 15/20 microns.
    Can you please suggest that what I missed ? or what next I need to do?
    Thanks in advance
    Last edited by joyunipol; 03-08-2019 at 06:30 AM.

  2. #2
    Join Date
    Dec 2009
    Posts
    947

    Re: How to bypass Linear scale in Fanuc Oi-MF controller

    now ,by that 15/20 microns you have the backlash on the ball screw or ballscrew bearings,this backlash was dicovered by your linear scale and if you are bypassing it now ,you use the motor encoder to position and the difference between what encoder see and where the axis is in real time result in a backlash.
    i should start by checking the axial movement of the ballscrew on the ends of it and release and tight again the nut on the end bearings of the ballscrew (opposite to motor side )and check again with a dial if it is still there the 15.20 microns.
    you can also adjust this backlash in parameter 1851 for every axis

  3. #3
    Join Date
    Feb 2019
    Posts
    7
    which Axis alarm sv410? This axis is a little move to alarm or move a distance and then alarm?

  4. #4
    Join Date
    Feb 2019
    Posts
    2
    Hi!
    Thanks for your time. there is no backlash and runs fine in 0 rapid. but at 25% rapid, y axis moves a little and it stops with a sudden breaks and SV0411 generates.

    On homing it changes its offset value by 15/20 micron which can't be adjusted in rapid backlash parameter. Local fanuc engineer also clueless.....any idea?

  5. #5
    Join Date
    Dec 2009
    Posts
    947

    Re: How to bypass Linear scale in Fanuc Oi-MF controller

    check very good the power connection wires from the motor and from drive

  6. #6
    Join Date
    Jun 2022
    Posts
    6

    Re: How to bypass Linear scale in Fanuc Oi-MF controller

    Can you please suggest that what I missed chinese buffets near me

    or what next I need to do?
    Thanks in advance

  7. #7
    Join Date
    Dec 2021
    Posts
    31

    Re: How to bypass Linear scale in Fanuc Oi-MF controller

    We produce DRO and linear scale, maybe it will help you, you can go to https://www.amazon.com/stores/HHXXOV...2?ref_=ast_bln
    view on
    Or on Whats: +8613528773691
    Contact me at [email protected], [email protected]

  8. #8
    Join Date
    Aug 2018
    Posts
    44

    Re: How to bypass Linear scale in Fanuc Oi-MF controller

    You needed to set few parameters ….
    Flexible gear, référence counter, cmr, not so simple….

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •