[machinebob1]

Hello, I just got a Okuma EX 3000II MYW. Wrote a program to cut some jaws works great , but when it got to the M2 I got a parts counter alarm. And it will not go away, reset turn power off and back on, still there.
Alarm says I have to set the counter value to 0, But for the life of me I cant find the parameter for the counter.
Anybody Help?
Thanks Bob.

[deadlykitten]

hi, it seems that your counter is on a wild trip

i don't use machine default counter, but i can try to look into that, on osp300 : pls share alarm code and counter interface / kindly

[OkumaWiz]

Check in your work counter screen. It should be in auto mode but you may have to extend the screen a time or 2. If older control then it may be in parameters.

[deadlykitten]

hello again, there may be a max limit for the nc work counter, and maybe you just reached it ? try to reset your actual counter

on osp300, look for [ F6 ] Nc opr monitor + page up / page down, so to reach "work counter " interface 1/3

also, as mr wizard said, you may need to extend the screen

i just input 99999999 inside the counter, and after the cycle completed, it changed to +overflow, but i could continue ...



hmm, this is deja-vu; i feel like i have given this advice a long time ago, but actually this is the 1st time ? my god, my memory

[machinebob1]

Thank you very much. Worked great.