584,830 active members*
5,749 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Leadshine > MX4660 and Mach3 Loader
Results 1 to 2 of 2
  1. #1
    Join Date
    Mar 2016
    Posts
    3

    MX4660 and Mach3 Loader

    I setup Mach3 on a XP Home computer (it has necessary requirements for Mach3-fresh install of XP Home SP3). When I go to open the MX4660 profile, it freezes my computer and I have to power it down. If I go to load Mach3 Mill, it opens without issue.

    I was running Mach3 on a laptop with a TB6560 board, so as a test, I put the MX4660 XML file in Mach3 folder and it loaded there just fine...

    Any suggestions as to the problem?

  2. #2
    Join Date
    Mar 2003
    Posts
    35538

    Re: MX4660 and Mach3 Loader

    Corrupt .xml file.
    Very common with Mach3.
    Always make a backup when you have everything working properly.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

Similar Threads

  1. Motors don't run - Mach3- Leadshine MX4660 - UC100 USB
    By pilotarix in forum Mach Software (ArtSoft software)
    Replies: 5
    Last Post: 05-13-2022, 06:46 AM
  2. Spindle Relay Control with Mach3 and MX4660
    By icecats in forum Mach Software (ArtSoft software)
    Replies: 6
    Last Post: 06-06-2017, 12:29 PM
  3. CNC Plasma table with MX4660, Mach3 and ESS
    By asuratman in forum Leadshine
    Replies: 4
    Last Post: 12-28-2016, 11:16 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •