Hey, I'm having troubles getting the depth to set on my router. I don't know if it's a suction or mill problem. The depth won't set for any bits including our mill bit. Any help appreciated.
Hey, I'm having troubles getting the depth to set on my router. I don't know if it's a suction or mill problem. The depth won't set for any bits including our mill bit. Any help appreciated.
What happens when you try? Describe the behaviour.
Did it work before?
What's changed between when it worked (assuming it did) and now?
Explain what happens when you try to calibrate.
Is it immediately going up when you hit your 0 key or does it keep going down, and acts like it doesn't see the block.
I had a similar problem. Turned out the surface block wire had broken internally. Check it for continuity.