I have a huanyang gt series gt-011g-2 VFD
It has auto tune but it blow a fuse when i try and run it
My spindle is a vevor
300Hz
RPM 18000
KW 7.5
AMP 15
2 POLL

On the programming it said to enter this data from spindle from plate
P2.01 Motor Power i put in 7.5
P2.02 Motor frequency (It will only go from range 0-50hz) I put in 50
P2.03 Motor speed 18000 is what i put in
P2.04 motor voltage 380 also tried 220V
P2.05 motor amp 15
It then says run auto tune P0.16 (option 1) then run

I also tried manually entering this data Is 300 wright on 50hz?
P0.03 I Set to 300
P0.04 I Set to 300
P0.06 I Set to 300
P2.02 I set to 300

Still blows fuse

I toned out the spindle wiring and installed a different brand that i am replacing because its under powered, It works fine.

What programming am i doing wrong?

Here is the manual
https://www.automationtechnologiesin...ies-manual.pdf

Thank you for any advise.