Hi,
Has anybody else had this happen with Mach4 Lathe Cycles?

Dell Desktop
CPU [email protected] Ghz
8 Gb ram
64 bit
Windows 10 Pro, Ver1803
...............
Mach4 Hobby 4.2.0.3804, Licensed

...............
PMDX 416
Gecko 540
...............
Turn Cycles

Program runs the OD Cycle, Tool 1010
then runs the Threading Cycle, Tool 1111
it finishes the physical threading OK.....
then near the end of the program just hangs there..... line with M09.....
It kicks out the Cycle Start/ GCode Button..... Greyed out... (Not sure but I think that is greyed out on any time the Cycle start Button is pressed?)

So I have to hit Disable Button n re-Enable Button n then hit Cycle Start n It will finish / Rewind Program back to beginning.

But if I do not post thread cycle but just turn cycle it will finish n rewind as it should at M30

Uploaded some files if you want test em n let me know if it works for you?


ThankX MM