[Maurice1]

Hi ; I m back at my Triac retrofit and it was recommended that I used the 485 connection of the VFD (Galt 200) I got some twisted wire and usb converter and I can get the drive started in the Modbus Control in test modbus and chnge the speed in Mach3 but I can stop it in Mach by pressing reset, probably don t have the right brain and Modbus configuration. Any help would be appreciated.

[hfjbuis]

Copy the brain that starts the VFD and change:

• The key on witch it has to response from the start key to the stop key
• Change the register this brain changes to the correct value probably 0 to stop the VFD

[Maurice1]

Hi hfjbuis;
few hour after I post the thread a friend of mind came over and we rearrange the Machtric S800 E brains that you can find on these site. and we watch the silent movie for the Bosch Rexroth E5610.The problem I was having I was using the wrong number to turn spindle on,off and stop in the brain. This is a good movie to watch to create a brain , I do appreciate the work that he put into it. Here is the link https://www.youtube.com/watch?v=AFbH6ps0hVY, hfjbuis thanks for your quick response.

[hfjbuis]

@Maurice1
I am great to hear it works OK. Thanks for the link to this video.