Hello there
Question about editing the post in edgecam as follows:
Is there any lists out there of functions that you can use to pull specific settings from the program onto the nc output.

Examble.
I want my stock dimensions to show in my NC-code

(************************************************* *******)
(* Prog. Navn : PPCMEK20124S1 )
(* Part Navn : MEK20124SIDE1 )
(* Maskine : MA 400HA )
(* Lavet af : MBW )
(* Postet d. : 03/07/19 - Klokken. 13:02:08 )
(*)
(* Total bearbejdningstid : 7.304 Minuter *)
(************************************************* ********)
( STOCK DIMENSIONS HERE)

Anyway this is possible?

Regards
Marc W