585,727 active members*
4,148 visitors online*
Register for free
Login

Thread: Sample Face Milling Program with Q Parameters

Results 1 to 2 of 2
  1. 03-09-2019, 09:39 PM #1
    KevinV_MEI
    KevinV_MEI is offline Member
    Join Date
    Dec 2010
    Posts
    152

    Sample Face Milling Program with Q Parameters

    I am trying to set up a simple face milling program using Q parameters to be used on a tnc426(no face milling canned cycle). Can anyone provide any samples or a place to start? I have the manual and am trying to put something together for an apprentice to just square and size blocks.
    Reply With Quote Reply With Quote
  2. 04-14-2019, 11:12 PM #2
    sudsy
    sudsy is offline Junior Member
    Join Date
    Sep 2012
    Posts
    216

    Re: Sample Face Milling Program with Q Parameters

    Chapter 10 covers this


    https://www.dropbox.com/s/duf0ydsavm...54-06.pdf?dl=0
    Regards Bob
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Sample program
    By pointpounder in forum Daewoo/Doosan
    Replies: 2
    Last Post: 10-09-2014, 09:58 PM
  2. Sample program
    By BoKo in forum Colchester Tornado lathes
    Replies: 1
    Last Post: 10-11-2010, 08:49 AM
  3. Sample program
    By BoKo in forum Daewoo/Doosan
    Replies: 2
    Last Post: 10-05-2010, 01:12 AM
  4. need sample program
    By vintageracer in forum Milltronics
    Replies: 3
    Last Post: 11-15-2008, 10:58 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules