[cadsculptor]

I have a MK1 board that I would like to replace with the MK3/4. It is running a small cnc engraver/router. Can I use all the other boards with the MK3?
Also, does the board include the PlanetCNC TNG license or do I have to buy that separately?
Thanks, Paul

[PlanetCNC]

What do you mean with "all other boards "? Do you use such engraver? https://planet-cnc.com/replacing-chi...rv-controller/

License is a separate purchase and it is not included with controller.

[cadsculptor]

Hi Planet, the controller in your link is exactly the one I have!
So, I can replace the Chinese junk with your MK3. But, I also have to buy the TNG license? Will your MK3 board work with LinuxCNC?

[harryn]

TNG is software.

MK3 board series is hardware.

Both are required to work.

If somehow you break the MK3 hardware, then you just purchase the hardware again, not the software.

[cadsculptor]

Thank you PlanetCNC and harryn.
Planet, yes, that is the unit i have. I want to take out the MK1 clone and replace it with your MK3/4 but keep the other boards (stepper drivers and power supply?).
Paul

[PlanetCNC]

Sure you can keep the PSU and stepper drivers. Would you mind posting some photos of your stepper drivers and PSU?