[basskitcase]

In Mach3 I was told not to use backlash comp when in CV mode. Does the same limitation apply with UCCNC? Just switched over yesterday.

[neptunier]

i use it in uccnc and it seams to work fine. no stopping in an arc as with mach3.
michael

[OlfCNC]

In Mach3 I was told not to use backlash comp when in CV mode. Does the same limitation apply with UCCNC? Just switched over yesterday.

I'm using it on the plasma and it works fine with the UCCNC. My machine has a small backlash about 0.2mm on the racks and pinions drive on the X and Y and the compensation is unnoticable, no stopping like how it happens with mach3.
I'm running the plasma machine always in G64 CV mode.

[basskitcase]

Thanks all, I will turn it on and give it a shot.