[almenyawe]

I had a Chinese Fiber laser unit for 2 years
Model: DTML-F(I)Pulsed Fiber Laser 5w-30w, IPG-YLP Control Card, EZCAD 2.5.3

After initial power-up:

I/o 4 input is on, light fires OK, but Marking is very Weak, I/o 4 input turns off.
the second try to mark Ezcad displays "IPG Laser:System Error!"

I believe either the software is not set up correctly, or the Laser Source is bad.

please guide me what is the problem and how to fix it

[ricky876]

sorry to wake this thread up but did you figure out this issue i am having the same issue with my Raycus 30w laser

[Opticlaser]

Turn on your laser source. I've had that error plenty of times and it's always when I forget to turn on the switch. If the switch is on then start checking to see if you have power to this source.

[Amitkumar25]

I am also facing same issue in IPG Ylp 30w, I am also using same Ecad 2.14 software and same way there is one errors showing in machine “Fiber laser system error ” so if anyone have a Solutation then please let me help and tell me the reason and solution for the same

[EZCAD]

It seems to be the  Laser Marking Software error, the software installed is EZCAD , you can visit www.ezcad.net to contact the manufacturer.