Does anyone know how to remove the bezel around the keypads on Okuma operator's panels? One of our keypads needs cleaning underneath and/or it has shifted and is not lined up properly with the contacts and so the buttons are very hard to press. I can't see how it comes apart though and it's not mentioned in any of the manuals. I tried prying it off gently, but that just resulted in cracking the bezel.
Results 1 to 3 of 3
-
03-11-2019, 04:18 PM #1
Registered
- Join Date
- Dec 2013
- Posts
- 29
MX-45VAE operator's panel/keypad disassembly
-
07-26-2019, 03:23 PM #2
Registered
- Join Date
- Dec 2013
- Posts
- 29
Re: MX-45VAE operator's panel/keypad disassembly
No one knows how to get the panel apart? I thought this would be an easy one.
-
07-26-2019, 03:50 PM #3
Member
- Join Date
- Jun 2015
- Posts
- 4154
Re: MX-45VAE operator's panel/keypad disassembly
hi, i opened the panel a few times, to change the batery, or the hdd, or to put some rubber on the buzzer, or to clean some buttons ... just get a screwdriver, it should be easy / kindly
Reply With QuoteSimilar Threads
-
Operator Control Panel vs Keyboard
By GeirAkselsen in forum Vertical Mill, Lathe Project LogReplies: 0Last Post: 02-08-2017, 10:48 PM -
15MB Operator panel
By cncsparky in forum FanucReplies: 1Last Post: 09-13-2014, 11:51 PM -
Series III Operator Panel
By GLCarlson in forum Tormach Personal CNC MillReplies: 1Last Post: 04-07-2012, 05:47 AM -
Accessing Software Operator Panel Oi-TC
By adamant in forum FanucReplies: 15Last Post: 02-26-2011, 07:44 AM -
CNC Operator Panel Design
By Al_The_Man in forum DIY CNC Router Table MachinesReplies: 17Last Post: 09-13-2004, 06:03 PM
Tags for this Thread
Posting Permissions
